SE-EV Videos

This page contains two videos for Sumitomo (SHI) Demag's new SE-EV Series of all-electric injection molding machines. Please be sure to scroll down the page to see both videos.

To be informed when new Sumitomo (SHI) Demag videos are available, please subscribe to our site on youtube.com at the following link: youtube.com/SSDinNA. Just use the Subscribe button at the top next to our site name.

  

SE50EV All-Electric with SL Screw: Lens Molding

Sumitomo (SHI) Demag SE-EV all-electric injection molding machine equipped with the SL (Spiral Logic) Screw Assembly running an 8-cavity mold for a 0.003g lens for a mobile phone (shot weight 1.7 g).
 

SE50EV All-Electric with SL Screw: PPS Molding

Sumitomo (SHI) Demag SE50EV all-electric injection molding machine molding a PPS (polyphenylene sulfide) joint weighing 22.6 grams. The machine is equipped with the SL (Spiral Logic) Screw Assembly.
 

SE130EV-HD All-Electric Injection Over-molding Demonstration

Sumitomo (SHI) Demag SE130EV-HD (High Duty) all-electric injection molding machine demonstrating over-molding of an automotive steering component using PA6 resin on a metal tube. The shot weight is 200 grams and the mold would typically be run in a 220 ton machine. A 45 mm SL (Spiral Logic) Screw Assembly is used in this demo.
 

SE180EV-LGP Light Guide Plate Injection Molding Demo

Sumitomo (SHI) Demag light guide panel/plate (LGP) molding demonstration with compression molding. An SE180EV-LGP all-electric injection molding machine runs a 2-cavity mold for the production of 7-inch LGP parts. The PC parts weigh 4.8 g each, with a total shot weight of 15.8 g. Maximum injection speed for the machine is 1200 mm/sec.
 

Medical Molding Demo on an SE100EV All-Electric at NPE 2012

Medical molding demonstration on a Sumitomo (SHI) Demag SE100EV all-electric injection molding machine at NPE 2012. The 32-cavity mold is running 0.266-gram PP (TOTAL #M6832 MZ) 200 Ál medical pipettes on a 6.5 second cycle.

  

SE180EV All Electric at NPE 2012

SE180EV all-electric injection molding machine running a StackTeck Systems Ltd. 4-cavity mold with Ritemp Technologies Pty evaporative cooling technology. Part is an HDPE return-drain-type pour spout, 9.1 g, run on a 7.5 s cycle.

Please use the SE-EV Info links above at left for more information about this new series of all-electric injection molding machines.